Quantity: 1234567891011121314151617181920

Nulon Engine Treatment is the greatest innovation in lubrication technology.  Nulon  Engine Treatment is a UNIQUE LUBRICANT formulated with activated PTFE (Poly Tetra Fluoro Ethylene, the slipperiest substance known to science) and other special additives that eliminates friction and smoothens the engine thus ensuring enhanced performance and total protection which help to significantly increase the life of your vehicles.

The major cause of component failure in any lubricant system is heat and wear & tear caused by friction. When two surface move in opposite directions, the peaks of the surfaces interact causing an abrasive action resulting in friction. Also, during normal running of the vehicle the irregular porous surfaces of the engine gets clogged with carbon and sludge leading to loss of power, higher fuel consumption and increased wear and tear. This prevents the engine from performing at its true potential.

Using engine oil alone is not sufficient. The ultra finesub micron particles of activated particles of PTFE, the lowest coefficient of friction (0.016 to 0.002) similar to wet ice sliding against wet ice which is present in Nulon when treated with engine oil first cleans the surface impurities and then forms an active uniform protective film of 0.5 micron on the moving parts of the engine, eliminating friction to near zero level and ensuring protection of engine and great benefits that NO ENGINE OIL CAN OFFER.

Since, Feb 2003 the Central Government has decided that all Petrol sold in the country would comprise of 5% ethanol.
As ethanol/solvents are priced at Rs.12 to 15/- per litre and are easily available in the everywhere. The retail outlets (petrol pump owners) tend to mix additional quantities of ethanol/solvents in the petrol at their pumps to increase their own profit. The pumps can significantly increase the margins they earn by this process of adulteration. Hence, most of the petrol available in India is adulterated in different percentages. The adulteration is especially high in smaller towns and rural areas.

This adulterated petrol causes the formation of acid and water when combusted in the engine. This acid reaches the lubricating oil. This acid degrades the lubricating oil and its lubricating properties and viscosity are eroded and hence the engine does not get the required essential lubrication and also the acid/moisture acts on the surface of the engine parts and damages them by pitting, eroding, corroding & formation of rust. These factors in turn result in various engine problems and even engine failure/seizer.

The OEM's are well aware of these facts as they are facing constant complaints from the buyers of the vehicles through their authorized dealers. Some of the manufacturers have even stopped giving Warrantees on their engines in certain markets.

Nulon Engine Treatment was tested by "ITL Labs Pvt. Ltd." Delhi a government approved ISO 9002 test house has confirmed that  " there is a formation of uniform film of 0.5 micron and that the film is inert to water, moisture, acids, alkalies, organic solvents, naphtha, Petroleum Ether and Benzene and also the friction is reduced".

1. Nulon Engine Treatment is formulated with activated PTFE (Poly Tetra Fluoro Ethylene) and other special proprietary additives blended in base oil. The activated PTFE content in Nulon Engine Treatment is inert and is NOT affected by acids, rust, corrosion, minerals, gases etc. formed inside the engine.
2. The activated PTFE forms an active protective film on all the engine parts and moving parts of the engine thereby giving protection to the metal parts and giving/enhancing the lubrication by eliminating friction to near zero levels. (The film prevents direct metal-to-metal contact)
3. This film prevents the acid/gases etc. formed during combustion of adulterated petrol to get in direct contact with the metal surface of the parts in the engine and thereby prevents the acid to do any harm and damage to the metal parts in the engine.
4. This film also enhances the lubrication by eliminating friction to near zero levels as PTFE is the slipperiest substance known to science, there by increasing fuel efficiency and giving other benefits which no engine oil offers.

• Protection of Engine from the effect of adulterated fuel.
• Average increase in fuel efficiency by 3% - 7%.
• Reduction in friction therefore reduction in wear and tear inside the engine and saving in downtime and maintenance costs.
• Increase in compression, which means more power and better pick up.
• Reduction in smoke emission levels.
• Reduction in noise & vibration levels.
• Smoother and quicker start-ups.
• Prevents damages to the engine due to cold startups.
• Increase the resale value of your car.

One can of Nulon E-25 Supreme Engine Treatment 350ml is suitable for all new and used cars, SUVS and jeeps.

Each application is effective for 15,000kms or 6 months whichever is earlier. The average cost for two wheelers works out to one paisa per km.

Step 1  Change engine oil and filter.
Step 2  Run engine for some time to ensure that engine is at normal operating temperature.
Step 3  ShakeNulon Engine Treatment 350/700ml can vigorously for at least two minutes.
Step 4  Stop engine and add contents of the can to engine oil sump.
Step 5  Restart engine.
Step 6  Run/Drive engine for at least 20 minutes.